GB
18
POINTS TO CHECK BEFORE CALLING THE TECHNICAL SERVICE
Prior to calling technical service, carry out these verifications that are mentioned
below.
•
The device is not working:
Make sure that the power cable is connected to the plug.
•
The pot is sticking to the glass:
If there is a molten material between the pot and the glass, try to separate them
by setting the heating plate to the maximum power.
•
Constant beep tone, control deactivation:
There is an object or liquid on the touch control. Remove the object or liquid on
the touch control
•
F0 message on the control while hob is connected:
Calibration fault. Cut off the connection of the hob and a couple of seconds later,
plug in again
•
Fc message and heating plates on the control close:
Overheating on the electrical parts. Leave the hob for cooling for a while.
•
FL message on the control:
High power light is active on the cooking part. Cut off the connection of the hob
and, a couple of seconds later, plug in again.
•
Fr message on the control:
Automatic control. Cut off the connection of the cooking part with network.
•
Other messages starting with “F” out of the ones above:
One-off fault. If the message does not disappear within a couple of minutes, call
Silverline Authorized Technical Service.
IF YOU STILL HAVE A PROBLEM WITH YOUR PRODUCT, PLEASE CONTACT THE
SILVERLINE AUTHORIZED SERVICE.
In order to find the nearest Sliverline Authorized Service to you, you may
consult to the authorized servide list which is provided to you along with the
product. If your list is older than
1
-
2
years, you can call SILVERLINE CALL
CENTER
+49 (0) 02181 75668 350
to get answer to your questions
This device has been labeled according to
2012
/
19
/EU Directive regarding the
Waste Electrical and Electronic Devices (WEEE). AEEE includes both
contaminant (these may cause harmful effects on environment) and essential
elements (these may be reusable).
You are required to prevent the negative consequences of this product to
the environment and human health before scapping or discarding it.
Subjecting of AEEE to special processes is important in order to discard all
the contaminants properly and all recycle and reuse all the materials. People
have an important role in ensuring that AEEE does not become an