18V Drill Driver
9
silverlinetools.com
Problem
Possible cause
Solution
Red LED (19) does not illuminate and Battery (12) not charging
Battery not fully seated
Clean Battery and Battery Charger contacts
Battery Charger (16) not powered
Recheck mains connection
Battery has low capacity
Battery not being fully charged
Charge the Battery until Red LED is extinguished
Battery has been charged over 300 times and capacity has
started to reduce
This is normal for batteries. Contact your Silverline dealer to
purchase a replacement battery
Drill cannot be switched ‘ON’ (ON/OFF Trigger Switch (15) does
not move)
The Forward/Reverse Switch (8) may be in the middle
(“locked”) position
Slide the Forward/Reverse Switch either to the left or right
Drill does not start when ON/OFF Trigger Switch is pressed
Battery completely discharged
Recharge Battery or replace with a fully charged battery
Defective Battery
Replace Battery
Drill defective
Contact your Silverline dealer or authorised service centre
Screws do not reach deep enough into the workpiece
Not enough torque; Torque Selector (3) setting too low
Choose a higher torque setting
Low battery voltage
Recharge Battery or replace with a fully charged battery
Screws are driven too deep into the workpiece surface
Too much torque; Torque Selector (3) setting too high
Choose a lower torque setting
Troubleshooting
975325_Manual.indd 9
26/03/2020 17:03
Summary of Contents for 975325
