![background image](http://html1.mh-extra.com/html/silverline/943676/943676_manual_1273615012.webp)
GB
12
Problem
Possible Cause
Solution
No detergent suction
Lance not in low pressure mode
Change setting with trigger released
Smoke
Overload or damaged motor
DO NOT USE. Contact dealer or authorised Silverline service centre immediately
Pressure washer doesn’t start
Pressurised
Squeeze trigger on gun before starting
Mains plug not fully inserted or mains socket is switched
OFF
Check and correct issues
RCD has operated or not been reset
Reset RCD
Plug fuse has blown (UK only)
Replace fuse and contact dealer if it blows again immediately
Thermal safety switch has operated
Switch OFF and allow pressure washer motor to cool before starting
Poor water spray pressure
Water inlet filter is clogged
Clean filter
Water hose connection is leaking or allowing air to enter
Check water hose connection
Pressure washer valves or seals are worn or damaged
Contact dealer or authorised Silverline service centre immediately
Fluctuating water pressure
Pump is sucking in air
Check water hose connections
Clogged nozzle
See Maintenance for cleaning procedure
Motor stops suddenly
Thermal safety switch has operated
Switch OFF and allow to cool before restarting
Water leaking from pump
Seals worn out
Contact dealer or authorised Silverline service centre immediately
Troubleshooting
943676_Manual.indd 12
31/05/2017 10:37
Summary of Contents for 943676
