GB
6
8. Switch the solder station ‘OFF’ when not in use, refer to ‘Switching ON and OFF’ to switch the
soldering iron ‘OFF’
9. Store the soldering iron in the Soldering Iron Holder when not in use
Accessories
• A range of accessories and consumables, including Soldering Sponges and Solder (AS16) and a
Soldering Iron Tip Set is available from your Silverline stockist
• Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING:
ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
Replacing the tip
Note:
Replacement tips can be found at a local Silverline stockist,.
WARNING:
Ensure the appliance is switched ‘OFF' and has fully cooled down before
attempting to change the Tip (5).
1. Hold the Handle (9) firmly
2. Unscrew the Tip Locking Ring (6) using a pair of suitable pliers, turning anticlockwise
3. Pull the Tip out and discard
4 Reverse this procedure to replace the Tip
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the appliance, prior to each use, for damage or wear. Repairs should
be carried out by an authorised Silverline service centre. This advice also applies to extension
cords used with this appliance
Cleaning
• Clean the Tip (5) before and after use using the damp Cleaning Pad (8)
• If necessary when the soldering iron has cooled, wire wool can be used to clean the tip more
thoroughly
• Keep your appliance clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine’s service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the appliance casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web:
silverlinetools.com/en-GB/Support
Address:
Powerbox
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this appliance carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power appliances that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
Problem
Possible cause
Solution
No function when On/Off Power Switch
(3) is operated
No power
Check power supply
Defective Power Switch
Replace the Power Switch at an authorised Silverline service centre
Handle (9) becomes excessively hot
Soldering iron has been left ‘ON’ for extended periods of time
Switch the soldering iron ‘OFF’ when not in use
Burning of the circuit board
Power setting too high
Lower the power setting using the Temperature Control Dial (2)
Solder not melting
Power setting too low
Raise the power setting using the Temperature Control Dial (2)
Soldering Iron Tip is too loose/ attached incorrectly
Turn the power OFF, wait for the soldering iron to cool and re-attach the Tip (5) correctly
Troubleshooting
245090_Manual.indd 6
11/12/2017 17:28
