- 62 -
• If necessary start playback of the external audio
device.
• Hold down the
SCAN/REC
button.
The notice
REC MMC
or
REC USB
appears.
• Press the
SCAN/REC
button several times to select
either the recording option
USB
(Recording to a
USB memory medium) or
MMC
(Recording to an
SD/MMC memory card).
• Start the copy process by pressing the button
BD/ENT
(
BAND/ENTER
on the remote control).
• To stop recording, briefly press the button
BD/ENT
(
BAND/ENTER
on the remote control) again. The
display changes to indicate the recording source
and the recording is saved.
Information regarding the recorded
data
The recording will be saved to the data carrier
with the following notations:
Audio CD recordings:
Track01, Track02 ...
MP3-CD recordings:
Music01, Music02 ...
Radio recordings:
Tuner01, Tuner02 ...
AUX recordings:
Line01, Line02 ...
Audio CD and radio recordings are recorded
in stereo and with a bitrate of 128 kbps
and/or a sampling frequency of 44 kHz.
When copying MP3 files the recording format
of the copy source will be adopted.
Deleting recordings/files from
USB/MMC
You can delete recordings or files stored in
MP3/WMA format on a USB or SD/MMC data
carrier.
• Press the button
LD/MD
(
MODE/LOUD
on the remote
control) to switch to USB or SD/MMC mode,
depending on where the file you would like to
delete is located.
• Select the file and hold the
SCAN/REC
button pressed
for about two seconds. The display shows
DELETE
.
• Press the button
BD/ENT
(
BAND/ENTER
on the remote con-
trol) to delete the current file from the data carrier.
Once the deletion process is finished, playback
continues with the next title.
Note:
Deleting of the file cannot be undone!
• If you do not wish to delete the file, press the
button
LD/MD
(
MODE/LOUD
on the remote control) or
wait about 5 seconds until the notice
DELETE
disappears from the display.
Replacing the fuse
The car radio is equipped with a 10 A fuse on the
rear panel, which blows if a voltage peak or a short
circuit should occur.
• In this case replace the fuse with one of equal
value and of the same type as listed in the technical
data with the same trip characteristics.
• Have an expert investigate the reason for tripping
of the fuse before switching the car radio on
again.
Troubleshooting
The device will not switch on
The ignition is not switched on
• Switch the ignition on by turning the key.
The fuse is defective.
• Replace the fuse.
The CD will not load or eject
A CD is already inserted into the car radio.
• Remove the CD.
The CD has been inserted the wrong way up.
• Insert the CD with the labelled side up.
The CD is dirty or defective.
• Clean the CD or insert a different CD.
The temperature in the vehicle is too high.
• Wait until the surrounding temperature has
normalized.
Condensation on the laser lens
• Switch the car radio off for a few hours and
then try it again.
IB_KH2381_41164_LB5 14.11.2008 9:19 Uhr Seite 62
