- 54 -
Operation
Operation via the buttons on the
device and on the remote control
Most of the functions can be operated by the
buttons on the device as well as by the cor-
responding buttons on the remote control. The
buttons on the device are described in these
instructions. If the buttons on the remote control
are meant this will be specifically mentioned.
Instead of pressing the multi controller described
in the manual, it is also possible to use the
SEL
button on the remote control.
Instead of turning the multi controller left or
right, it is also possible to use the
VOL-
and
VOL+
buttons on the remote control.
Note
Approx. 5 seconds after a setting has been
made the playback will again be displayed
and the setting is saved.
Basic operation
Switching On and Off
Briefly press the button
PWR/DIM
(
POWER/DIM
on the
remote control) to switch on the radio. In the display
the notice
WELCOME
appears.
• Briefly touch the
PWR/DIM
button to dim the dis-
play illumination.
To switch off, hold down the
PWR/DIM
button longer.
The notice
GOOD BYE
appears in the display.
Volume
• Turn the multi controller to increase or decrease
the volume.
Attention!
Always set the volume to a level that will allow
you, at any time, to clearly hear acoustical
signals from emergency service vehicles!
MUTE - Switch off the sound
Press the button
MU
(
MUTE
on the remote control) to
switch off the sound. The message
MUTE
appears
on the display.
To switch the sound back on, press the button
MU
again or turn the multi controller. The
MUTE
indicator
goes out.
Bass/Treble/Balance/Fader
• Press the multi controller to display the current
settings for volume (
VOL
) bass (
BAS
), treble
(
TRE
), balance (
BAL
) and fader (
FAD
).
• Turn the multi controller to change the settings.
Note
When the DSP equalizer is on, the settings
for BASS and TREBLE are not available.
Loudness
• Hold the button
LD/MD
(
MODE/LOUD
on the remote
control) pressed to switch the loudness function
on or off.
When the loudness function is switched on,
LOUD
ON
is shown in the display, and
LOUD OFF
is
shown when the loudness function is switched off.
Display
• By pressing the
DISP
button you can switch the
notices in the display around in the following
manner:
With radio reception:
PS (Programme name), time of day (will automati-
cally be set with RDS reception), PTY settings (these
RDS functions are transmitted by the broadcast institu-
tions in various extents; see also the chapter "Radio func-
tions") and frequencies.
In CD mode:
Time, PTY settings, frequency and PS (Programme
name).
IB_KH2381_41164_LB5 14.11.2008 9:19 Uhr Seite 54