Silvercrest 75466, Operating Instructions Manual

Page: 48 / 173

- 46 -
Working with the food
processor
Note:
Ensure that on the swivel arm
h
neither
the kneading hooks
q
, the whisk
e
nor the
mixing beater
w
are attached.
Proceed as follows to prepare the appliance for
operation with the food processor
u
:
• Press the unlocking button
f
down and bring
the swivel arm
h
into operating position 4
(see chapter "Operating positions“) (Fig ).
• Insert the mixing bowl
y
. The base of the mixing
bowl
y
must engage in the recesses
k
on the
appliance.
• Press the unlocking button
f
down and bring
the swivel arm
h
into operating position 1
(see chapter "Operating positions“).
• Remove the drive protection lid for the food
processor
u
(Fig. ).
• Insert the food processor
u
into the drive opening
(The "dot" marking on the food processor
u
to
the "arrow" marking on the swivel arm
h
) and
then turn it clockwise as far as it will go (The "lock"
marking on the food processor
u
onto the
"arrow" marking on the swivel arm
h
).
• Insert the drive shaft
a
.
• Depending on the task to be performed, place
the cutting
s
, rasping
o
or rubbing
i
disc
onto the drive shaft
a
of the food processor
u
.
• Place the lid with stodger
d
onto the food pro-
cessor
u
and latch it down.
• Set the rotary switch
g
to the desired level.
Note:
Do not press too many ingredients in the
food processor
u
. Take note of the table in the
chapter „Recommended filling quantities“.
• Insert ingredients through the loading shaft with
the stodger
d
.
Risk of injury from rotating parts!
To avoid personal injury and damage to the appli-
ance, NEVER insert or place your hands or foreign
objects into the loading shaft. Only insert ingre-
dients by use of the stodger.
Only change accessories when the drive motor
j
is at standstill! After being switched off, the drive
motor
j
continues to run for a short time. The ap-
pliance may only be used when the drive openings
not being utilised are covered with drive protection
lids. In cases of malfunction switch the appliance
off and remove the plug from the wall socket,
this will avoid an unintentional switching-on of the
appliance.
On task completion
• Switch the appliance off with the rotary switch
g
.
• Turn the food processor
u
anti-clockwise and
remove it.
• Disassemble the food processor
u
and clean all
parts (see chapter „Cleaning and care“).
Working with the mixer
Risk of scalds!
Allow hot fluids to cool to a hand-warm temperature
(ca. 30–40°C) before they are poured into the
mixer
r
.
Proceed as follows to prepare the appliance for opera-
tion with the mixer
r
:
• Press the unlocking button
f
and bring the
swivel arm
h
into operating position 3 (see
chapter „Operating positions“).
• Remove the drive protection lid for the mixer
(Fig. ).
• Fit the mixer
r
("Arrow" marking on the base
to the "point" on the base unit) and turn it anti-
clockwise as far as it will go (Fig.
).