Installing or Removing a Memory DIMM
007-4564-001
63
Installing or Removing a Memory DIMM
The Silicon Graphics
®
Tezro™ visual workstation is configured with a minimum of 512
MB of memory and a maximum of 8 GB of memory. The memory is contained in dual
in-line memory modules (DIMMs) which are installed in eight DIMM sockets on the
system node board. The sockets are divided into four DIMM pairs. The instructions in
the following sections assume that you know the correct slots in which to install the
memory DIMMs. For information about DIMM configurations and placement rules,
refer to “Memory DIMMs” in Chapter 2.
Note:
If you have not already done so, remove the right side of the enclosure to access
the DIMMS. Refer to “Preparing the Workstation for Service” on page 49.
Instructions are provided in the following sections:
•
“Removing a DIMM” on page 64
•
“Installing a DIMM” on page 65
•
“Verifying Memory Installation” on page 66
Summary of Contents for Tezro
