Silicon Graphics Tezro, Hardware User'S Manual, Page: 74 / 174

52 007-4564-001
3: Maintenance and Upgrade Procedures
Determining Which Enclosure Panels to Remove
To determine which side(s) of the enclosure you need to remove to access specific
components, see Table 3-1. If a part appears in two columns, you must remove both
panels in order to access that component.
Note: Table 3-1 assumes that you are looking at the front of the workstation.
After you have determined which side(s) of the enclosure you need to open, proceed to
the appropriate section.
Removing the Left or Right Side Panel
Follow these steps to open the left or right side of the enclosure:
1. Press the panel release button on the rear of the enclosure. Then swing the top edge
of the panel away from the enclosure (see Figure 3-3).
2. Lift the panel until the hooks on the bottom edge clear the lip on the base of the
enclosure. Then swing the bottom edge of the panel away from the enclosure and
place it in a safe location (see Figure 3-3).
Table 3-1 Component Access by Enclosure Panel
Right Side Panel Left Side Panel Front Side Panel (Bezel)
Memory DIMMS
Hard Disk Drive Fan
Rear Fan Assembly
IO9 board
XIO boards
L1 display cable
LED cable
PCI boards
DVD-ROM drive
Fan wall
L1 display
L1 display cable
LED cable