Changing TCP/IP Settings
47
3. Select TCP Setup; Figure 4-4 shows the screen that appears.
Figure 4-4
Hub Setup: TCP
Note:
The default settings in this screen are recommended; do not change these
values unless you have good reason to do so.
Enter the IP address, and, if applicable, subnet mask and gateway address.
The check boxes at the bottom of this screen control automatic IP address
maintenance. Automatic IP maintenance can make use of any combination of BootP,
RARP, and DHCP. The choices have the following meanings:
•
Manual: automatic acquisition is not used.
•
Automatic - Permanent: The software looks for an automatically acquired
address only when the Digital Hub Manager has no IP address. Once an IP
address is found, it is saved for subsequent restarts.
•
Automatic - Temporary: The software looks for an automatically acquired
address every time the Digital Hub Manager restarts.
4. If required, change subnet mask and gateway address in this screen.
5. When the entries are the way you want them, click
Apply
.
