13
If more than 10 bidirectional receivers are being programmed at the
same time, the transmitter channel in programming mode switches
to group mode. The group mode is indicated by fast
fl
ashing with
pauses.
Programming in group mode is completed after a 2-minute pause or
pressing the
STOP
button for 6 seconds.
5.
Press the
CLOSE
button and the
P
programming button (rear of
unit) simultaneously (for 3 seconds) on a transmitter which has
already been programmed to the receiver . The status display
fl
ashes. The receivers are now in programming mode.
6. For bidirectional operation only: press the programming button
P
on the transmitter to be programmed until the status display
lights brie
fl
y. The receivers are now in programming mode
(open / close movements).
7. Press the
OPEN
button as soon as the blind starts moving
in Open direction (within no more than 1 second). The status
display lights brie
fl
y. The blinds stop brie
fl
y, start moving again,
stop and then move downwards.
8. Immediately (within no more than 1 second) after close travel
has started, press the
CLOSE
button. The status display lights
brie
fl
y. The blinds stop moving. The transmitter channel is
programmed.
Stopping programming mode (bidirectional) in the
transmitter
Press the
STOP
button for at least 6 seconds until the status display
lights orange.
Approaching end positions
Requirement
The transmitter/transmitter channel is programmed. The end
positions of the drive have been set.
Explanation of functions
