12
Programming additional transmitters
Note
If
several receivers
are connected to the
same supply
line,
then all are simultaneously in programming mode for
approximately 5 minutes after the mains power is switched on.
If the
P
button on the transmitter is now pressed, all the
receivers start programming mode at the same time
(open / close movements). Randomly different intervals between
open / close movements cause the receivers to become offset
against one another. The longer programming is delayed, the
greater the offset will be.
The short open / close movements can be stopped by pressing
the
STOP
button brie
fl
y on a transmitter which has already
been programmed. The programming mode in the receiver is
interrupted.
The transmitter can now be assigned without having to
disconnect individual receivers. If the blind moves in the wrong
direction, delete the transmitter and program it again.
(
→
see Deletion of transmitter)
For programming additional transmitters to one receiver:
1. Press the
OPEN
,
CLOSE
buttons and the programming button
P
(rear of unit) simultaneously (for 3 seconds) on a transmitter
which has already been programmed to the receiver. The status
display lights brie
fl
y. The receiver is now in programming mode.
2. Press the programming button
P
on the transmitter to be
programmed until the status display lights brie
fl
y. The receiver is
now in programming mode (open / close movements).
3. Press the
OPEN
button as soon as the blind starts moving in
Open direction (within 1 second at the most). The status display
lights brie
fl
y. The blind stops brie
fl
y, starts moving again and
then moves downwards.
4. Immediately (within no more than 1 second) after close travel
has started, press the
CLOSE
button. The status display lights
brie
fl
y. The blind stops. The transmitter channel is programmed.
