Operating Manual
Matrix
Copyright Silca 2012
30
9.5 CUTTING FICHET TYPE KEYS (H PROFILE)
1) Open the clamps slightly by loosening the knobs (E) (E1).
2) Fit the adapters and take them up against the clamps (Fig. 51).
3) Insert the keys taking the stop up against the adapter (Fig. 52).
4) Secure adapters and keys by tightening the knobs (E) (E1).
Check that the motor ON switch (Q) is OFF.
5) Disable the tracer point spring (Ch. 8.4).
6) Adjust the spring for the laser key carriage (Ch.8.5 - central cuts) Optional.
7) Grip the levers (C) and (D).
8) Press the button (D1) and lower the vertical carriage.
9) Keep the clamp carriage still with the left-hand lever (C); lower the tool unit with the right-
hand lever (D), stopping before coming into contact with the clamp (close to the key).
10) Without exerting pressure, turn the lever (D) clockwise to lock the height reached (Fig.
11) Start the motor with the switch (Q).
12) Move the lever (C) to trace all the cuts on the key with the tracer point.
Note:
•
For right-hand cuts it is advisable to make the cuts by moving the tracer point from the head to the tip.
•
For left-hand cuts it is advisable to make the cuts by moving the tracer point from the tip to the head.
13) When side 1 has been cut, turn off the motor with the switch (Q).
14)
Remove both keys, turn 180 and fit them into their clamps/adapters again. Start the motor with the switch (Q)
and make the cuts.
D910534ZR
STANDARD on vers.230V
OPTIONAL on vers.120V
Fig. 51
Fig. 52
Fig. 53
