Operating Manual
Matrix
Copyright Silca 2012
42
10.14 REPLACING THE jAWS
Make sure the motor ON switch is OFF
10.14.1 REPLACING THE LEFT-HAND STATIONARY jAWS
1) Loosen the 2 screws (B3) and remove the jaw.
2) Fit the new jaw up against the left-hand side and align also from the front (Fig. 86).
3) Tighten the 2 screws (B3) without exerting pressure.
4) Check alignment (Ch. 10.13.1) and then fully tighten the 2 screws (B3).
Fig. 85
Fig. 86
10.14.2 REPLACING RIGHT-HAND STATIONARY jAWS
1) Loosen the 2 screws (H3) and remove the jaw.
2)
Carefully clean the seat and fit the new jaw up against the right-hand side and align also from the front(Fig. 88).
3) Tighten the 2 screws (H3) without exerting pressure.
4) Check alignment (Ch. 10.13.2) and then fully tighten the 2 screws (H3).
Fig. 87
Fig. 88
