Operating Manual
Matrix
Copyright Silca 2012
29
9.4.1 CUTTING LASER KEYS WITH NARROW STEMS
Another function of the clamp is to cut laser keys with narrow stems by fitting the
adapter M (standard on 120V version, optional on 230V version).
Follow the instructions below:
1) open the clamps by loosening the knobs (E) (E1).
Silca ref.
HU41P, HU64P, HU64T - HU81T
:
2)
fit the adapter onto the left-hand clamp and align the groove with the one on the clamp for “Stop 2” (Fig. 49).
Silca ref.
HU55P
:
3)
fit the adapter onto the left-hand clamp and align the groove with the one on the clamp for “Stop 3” (Fig. 50).
4) slide the stop bar into the groove.
5) insert the key and take it right up against the bar.
6) secure adapter and key by tightening the knob (E).
7) remove the bar and repeat the same operation on the right-hand clamp.
Cutting:
8) disable the tracer point spring (cap.8.4).
9) grip the levers (C) and (D).
10) press the button (D1) and lower the vertical carriage to start the motor.
11) hold the clamp carriage still with the left-hand lever (C) and lower the tool unit with the right-hand lever (D) until
the tracer point touches the depth of the cut.
12) without exerting pressure, turn the lever (D) clockwise to block the height.
13) move the lever (C) to trace all the cuts on the key with the tracer point.
•
For left-hand cuts we advise tracing the cuts by taking the tracer point from the tip to the head.
14)
when the first side has been cut, turn off the motor with switch (Q).
15) remove the key blank only and turn 180° to cut the second side. The key has the same cuts on both sides.
16) re-start the motor with switch (Q) and proceed with cutting.
D910533ZR
STANDARD on vers.120V
OPTIONAL on vers. 230V
Fig. 48
HU41P - HU64P - HU64T - HU81T
HU55P
Fig. 49
Fig. 50
