EH-1200F Installation Manual
Page 30
2.8.5
Removing Connectors from the EtherHaul ODU
Caution:
To avoid accidental damage to the connector, always use the following order to
remove cable connections from the ODU.
1.
Unscrew the cable inlet portion (
) of the All-Weather shell to release the
gasket seal and then remove tension from the cable connector.
2.
Unscrew the connector outlet portion (
) of the All-Weather shell from its ODU
port.
3.
Remove the cable connector from its port.
2.8.6
Connecting DC Power
1.
Carefully screw the connector outlet portion (
)
of the All-Weather shell into
the PWR port. Tighten the connector outlet portion securely by hand (do not use
tools).
2.
Insert the power connector into the port. The PWR LED color indicator turn s red
for one second, then blinks green indicating that the ODU is powered on.
3.
Screw the cable inlet portion (
)
of the All-Weather shell onto the secured
connector outlet portion, taking care not to twist the connecting cable. Tighten
the cable inlet portion securely by hand. The rubber gasket insert (
) will
tighten to create a moisture-proof seal (do not use tools).
4.
Secure the power supply cable into place using a cable tie. Ensure that there is
sufficient play in the cabling to allow movement of the ODU during final
alignment.
5.
Wait for the EtherHaul ODU to boot up (about two minutes). When the ODU is
fully rebooted, the PWR LED color indicator turns green (during power-up the
PWR LED blinks green) and the RF LED color indicator turns off, indicating that
the link is down.
2.8.7
Connecting Other Interfaces
For each network connection, perform the following steps:
6.
Carefully screw the connector outlet portion (
)
of the All-Weather shell into
the appropriate port. Tighten the connector outlet portion securely by hand (do
not use tools).
2.
Insert the RJ45 or SFP connector into the port.
7.
Screw the cable inlet portion (
)
of the All-Weather shell onto the secured top
portion, taking care not to twist the connecting cable.
8.
Tighten the bottom portion securely by hand. The rubber gasket insert (
)
tightens to create a moisture-proof seal (do not use tools).
