EtherHaul™ 8000 Installation, Operation and Maintenance Manual
Page 23
5.
Use the 13mm open wrench to tighten the nuts on both unit mounting bolts.
Temporarily tighten the unit mounting bolts at this stage to keep the unit from
moving freely.
6.
Verify that quick release plate (
) is attached according to the desired
polarization. If necessary, change the radio polarization to match the orientation
of the remote radio by removing the quick release plate, changing its
orientation, and reattaching. For ease of reference, the markings V (vertical) and
H (horizontal) are engraved on the back side of the radio.
7.
Examine the position scales of both the Azimuth adjustment lock bolts (
) and
the elevation adjustment lock bolts (
), found on the front mounting bracket,
and ensure that they are positioned at 0 degrees (in the middle of the scale).
8.
Position the quick release hooks (
) onto the top elevation adjustment lock bolt
(
) and carefully set the radio in place on the front mounting bracket and slide
it firmly inwards.
Hint:
Mount the radio by attaching the interior quick release hook (A) in place before
attaching the exterior hook (B). The interior hook is the one located farthest from the
tightening nut, as shown below.
A.
Interior Quick Release Hook
B.
Exterior Quick Release Hook
C.
Elevation Position Slot
Figure 2-4 Quick Release Hooks
9.
Unlock the Azimuth adjustment lock bolts (
) and the elevation adjustment lock
bolts (
).
10.
Stretch the elevation screw tension band (
) slightly and connect it to its
mating tension pin, located on the quick release plate.
