EtherHaul™ 8000 Installation, Operation and Maintenance Manual
Page 22
2.6.2
Mounting using 1ft Mounting Kit
1. Unit mounting screws and bolts
6. Azimuth adjustment lock bolts
2. Back mounting bracket
7. Elevation adjustment lock bolts
3. Front mounting bracket
8. Azimuth fine adjustment screw (± 8
)
4. Quick release plate (attached to radio)
9. Elevation fine adjustment screw (± 16
)
5. Quick release hooks
10. Elevation screw tension band and pin
Figure 2-3 1ft Mounting Kit Components
Note:
Torque level for tightening all nuts and bolts is 8nm.
1.
Prior to mounting, unpack the mounting kit package and attach the two unit
mounting screws (
) to the front mounting bracket (
), securing them with
mounting bolts.
2.
Assemble the back (
) mounting bracket to the front (
) mounting bracket
using one bolt and separate them by about 120 degrees so that the assembly
can to be attached to the mounting pole.
3.
Place the assembly on the mounting pole and rotate the front and back
mounting brackets to fit the assembly on the pole. Add the unit mounting bolt
that was removed.
4.
Ensure that both front and back mounting brackets are attached evenly to the
pole, and are completely level.
