SII DPU-S445 SERIES, Technical Reference

Page: 37 / 176

4-8
4.1.4 Function Settings(SWDIP4)
Table 4-4 Function S s (SWDIP4)
Value
etting
SW n
0 1
DIP Functio
4
etooth Link Key Selection
Key)
Enable -8
(Bluetooth Link
Blu
Disable
4 ix to 1 -7 Reserved F
4
Busy Output When Error
)
sy -6
Occurs (Error
Unbu Busy
4 Position Correct Enab -5 Mark le Disable
4-4
4-3
Bluetooth Baud Rate See below
4-2 CTS Control Enable Disable
4-1 Auto Activation by AC Enable Disable
nk Key Selection
ble, the printer saves the link key from the host device to connect in the
nter can connect to
e printer processes PIN
de as '0000'.
r Occurs
en an error occurs.
become busy status while an error occurs and
on turns to busy
st s.
on Correct selection
When Mark Position Correct selection sets to Enable and Paper Mode SWDIP3-1 to 3-2 is selected
to Mark Roll Paper, the printer feeds the paper roll in backward as following conditions:

Beginning of a printing right after power-on or resetting.

Beginning of a printing right after performance paper home feed by FEED switch or page
feed execution.
To use this function, there are several restrictions. Refer to 2.2 SPECIFIED THERMAL PAPER
SPECIFICATION.

Bluetooth Li
This function is set to Ena
pairing process. When once a pairing is performed for the host device, the pri
the host device using the link key from the next time without a pairing.
If this function is set to Enable and PIN code is not specified in advance, th
co

Busy Output When Erro
This function can select whether data reception becomes busy status or not wh
If this function is disabled, data reception does not
data reception is available.
However, regardless of this setting if receiving buffer becomes full, data recepti
atu

Mark Positi