1/27/15
SigC667x / SigC641x User Guide, Rev B7
Copyright
Signalogic 2012-2014
71 / 109
Figure 4-25, Display after entering Algorithm Mode and toggling AGC Active
If a digital scope is connected as shown in “Notes and Equipment” section above, note that
effects of AGC are visible on the scope. If AGC is not active, then the output trace (green) will
show a flat line (zero pattern) for any unused channels. If AGC is active, then the output trace
will show a constant, non-zero pattern for any unused channels. (Remember that if N calls are
set up, then unused channels start after 2*N channels on the scope display).
15) Exit Algorithm Mode (press ‘a’ key again) and then press the ‘d’ key to display a “diagnostic
readout” showing current call state information maintained by the target code. You should see a
display similar to Figure 4-26 below:
