30
MIG Welding
1.
Insert the earth cable plug into the negative socket on the front of the machine and tighten it.
2.
Plug the welding torch into the MIG torch connection socket on the front panel of the wire feeder,
and tighten it.
IMPORTANT!
When connecting the torch be sure to tighten the connection. A loose connection can
result in the connector arcing and damaging the machine and gun connector.
3.
Connect the water inlet and outlet pipe of MIG Gun to the water inlet and outlet
connectors on the
front of the wire feeder.
4.
Connect the gas line to gas connector on the rear panel of wire feeder.
Check for Leaks!
5.
Connect the control cable of wire feeder with the aero socket on the rear panel of welding machine.
6.
Connect the cable of wire feeder with the positive output of welding machine.
7.
Connect the water inlet and outlet pipe of wire feeder with the water inlet and outlet connectors on
the rear front of cooling water.
8.
Connect the control cable of cooling water with the aero socket on the rear panel of welding machine.
9.
Connect the power cable of welding machine with the output switch in electric box on site.
DIAGRAM FOR GUN
22
Installation & Operation for MIG Welding
Set up installation for MIG Welding
(1) Insert the earth cable plug into the negative socket on the front of the machine and
tighten it.
(2) Plug the welding torch into the MIG torch connection socket on the front panel of the
wire feeder, and tighten it.
IMPORTANT:
When connecting the torch be sure to tighten the connection. A loose
connection can result in the connector arcing and damaging the machine and gun
connector.
(3) Connect the water inlet and outlet pipe of MIG Gun to the water inlet and outlet
NOTE!
Air cooling mode without cooling device and the water pipe is not needed for the air cooling mode.
Summary of Contents for Evolution MTS500 DP
Page 44: ...44 Notes ...
Page 45: ...45 Notes ...
