39
INSTALLATION & OPERATION
3
(7) Connect the gas line to gas connector on the rear panel.
(8) Connect the power cord of welding machine with the outlet on electrical box.
(13) Carefully open the gas cylinder valve and set the required gas flow rate.
(14) Set welding parameters using the knobs as shown on digital displays.
(11) Feed the wire through the drive
rolls and into the inlet guide tube.
Tighten the wire tension swing arm.
(12) Pull the trigger to drive the wire down
the neck until it exits the contact tip.
(9) Remove the spool cover by pressing
button and lifting off the cover.
(10) Place a spool of wire inside the
spool holder on post.
INSTALLATION & OPERATION
3
(7) Connect the gas line to gas connector on the rear panel.
(8) Connect the power cord of welding machine with the outlet on electrical box.
(13) Carefully open the gas cylinder valve and set the required gas flow rate.
(14) Set welding parameters using the knobs as shown on digital displays.
(11) Feed the wire through the drive
rolls and into the inlet guide tube.
Tighten the wire tension swing arm.
(12) Pull the trigger to drive the wire down
the neck until it exits the contact tip.
(9) Remove the spool cover by pressing
button and lifting off the cover.
(10) Place a spool of wire inside the
spool holder on post.
9.
Remove the spool cover by pressing
button and lifting off the cover.
10.
Place a spool of wire inside the
spool holder.
11.
Feed the wire through the drive rolls and
into the inlet guide tube. Swing back and clip down
the wire tension swing arm.
12.
Pull the trigger to drive the wire through the
neck until it exits the contact tip holder.
13.
Carefully open the gas cylinder valve and set the required gas flow rate.
14.
Select spool gun mode using the knob. Set welding parameters using the knobs.
Summary of Contents for Evolution MTS500 DP
Page 44: ...44 Notes ...
Page 45: ...45 Notes ...
