Rev 002
17
AirPrime XM0110 Development Kit
Daughter Board
Quick Start Steps
2. Download the application to your module
a. Enter
AT+WDWL
command in terminal.
b. Once characters §§§§§§ appear, select
Transfer |
Send file
from the main menu:
c. Select the application binary: xxx.dwl
d. Select
1K Xmodem
Protocol
e. Click
Send
to start loading. This phase will take about 1 minute.
f.
After download complete, enter
AT+CFUN=1
to reset the module
2.4.3.
GPS AT Command Application Start
1. Enter
AT+WOPEN=0
It is recommended to then enter AT+WOPEN=3 to clean flash objects if an earlier Location
Plug-In version has been used before
2. Enter
AT+WOPEN=1
to start the application, and thus GPS AT Command set
The module restarts ponds with OK and restarts
3. Enter
AT+GPSSTART
to start GPS Plug-In.
The module responds with OK, then immediately with +GPSEVINIT: 1
4. On daughter board you will observe the following sequence:
XM0110 ON
LED switches ON.
GPS STATE
LED starts blinking rapidly
