Rev 002
13
AirPrime XM0110 Development Kit
Daughter Board
Quick Start Steps
2.3.2.
XM0110 Development Kit Daughter Board
Configuration
2.3.2.1.
Hardware Version
XM0110_DevKit_DB WM0701201-023-20 or later.
Caution:
If you are using a daughter board version WM0701201-023-10, please read section 2.5.3
with older dev kit daughter board version WM0701201-023-10
2.3.2.2.
Setup
The 7 jumpers on the XM0110 Daughter Boards must be set to select the UART interface, ON/OFF
controlled by GPIO, 32K coming from HOST and NO Interrupt as represented on the picture below.
Figure 3.
XM0110 Development Kit Daughter Board jumpers configuration for Quick Start
Connect the GPS antenna provided with the development kit is an active antenna. The XM0110 Dev
Kit Daughter Board will supply this antenna with 3V by default when connected.
Caution:
If connecting another kind of antenna or a GPS simulator, the user must be conscious of the 3V
supplied on the GPS connector and use, if needed, a DC blocker.
GPS antenna
connector
„ON/OFF‟ jumper on „GPIO‟
position
Communication bus 4
jumpers on UART position
„32K‟ jumper on „HOST‟
position
„INT‟ jumper on „NO‟ position
