Commissioning
7.3 Description of OSD menu
SMD 18101 CS / SMD 18101 CP / SMD 18101 D
Instruction Manual, 11/2005, A5E00472377A-002
7-7
Main menu
Functions
Adjustment/range
Description /
The "Position / Zoom" menu
is used to change the size
and position of the picture on
the display
H-position
Slider from 0 ... 100
Shift picture in horizontal
direction
If the display and graphics
card resolutions are
identical, an optimum
adjustment is achieved
where the picture occupies
the complete area of the
display and is not offset by
even one single pixel.
V-position
Slider from 0 ... 100
Shift picture in vertical
direction
Selection between four
different picture size settings
One to one
The picture is displayed in
original size on the screen
Fill screen
The picture is displayed to fill
the complete screen
(1280 x 1024 pixels)
Fill to aspect ratio
The picture is zoomed to the
maximum screen area with
retention of the aspect ratio.
Position / Zoom (U)
Zoom (only with analog
mode and PIP "off“)
Fill to square
The picture is zoomed to
square format
Source (U)
BNC
DVI Digital
Video
S-Video
VGA
Select source for main
display:
Select by pressing the Menu
key, and activate by pressing
the Up key.
Use the "Source" menu to
select the picture source for
the display with full format
Following switching off and
on of the display, the last
picture source is displayed
again. It is irrelevant whether
the picture source was
selected using the OSD or
the Up/Down keys.
Auto functions (U)
Auto brightness/contrast
Auto
position/phase/frequency
→ Execute selected
autofunctions
On/off
On/off
Execute autofunctions
The autofunction is used to
assist the automatic setting
of parameters:
•
Frequency,
•
phase,
•
position,
•
brightness and
•
contrast.
The quality of the settings
depends on the picture
contents and the type of
synchronization.
All settings can of course
