Firmware Configuration Tools
ACC USB Client Application
1
6 | 38
A6V11164550
1.1.2
Configuring the ACC USB Client Application
First time that the ACC is plugged in via the USB-B port, it may take a minute or
two to configure the USB to Ethernet interface. This is normal, and the delay
should not occur again.
1.
Run the ACC USB client application.
The
ACC USB Client Login
dialog is displayed.
2.
Enter the default user name and password to start the Telnet session for
configuring the ACC network parameters.
If you are using MP2.70 (or later) version of the ACC and the default (or
weak) password is set, you will be prompted to enter a new password
before configuring the network settings.
If you are using MP2.70 SP1 (or later) version, when you change the
SIEMENS
user password, the password for the “root” user for a SSH
connection will also be changed to the same password that was set for the
SIEMENS user.
3.
Set the following parameters for the ACC in
Network Settings
section:
–
Ethernet IP address
–
Subnet mask
–
Gateway IP address
–
Host IP address
–
Port
4.
Click Apply
