Operation
140
SIPART PS2 Manual
A5E00074631--06
Messages during the installation phase:
Upper lin
e
Lower lin
e
Meaning/cause
Measure
P----
x
See above
See above
RUN 1
x
Initialization has been started, part 1
is active
(direction of action is being
determined)
S
Wait
RUN 2
x
Initialization, part 2 is active
(actuator travel check and
determination of the end stops)
S
Wait
RUN 3
x
Initialization, part 3 is active
(determination and display of the
actuating times)
S
Wait
RUN 4
x
Initialization, part 4 is active
(determination of the minimum
actuator increment length)
S
Wait
RUN 5
x
Initialization, part 5 is active
(optimization of the transient
response)
S
Wait until “FINSH” is displayed
(initialization completed successfully)
S
Press the operating mode button
briefly to acknowledge and exit the
configuration level by pressing it
continuously
YEND1
x
only for manual initialization
first end position can be approached
S
Approach first end position with the
“+” or “--” button
S
Press operating mode button to
acknowledge
YEND2
only for manual initialization
second end position can be
approached
S
Approach second end position with
the “+” or “--” button
S
Press operating mode button to
acknowledge
RANGE
x
only for manual initialization
End position or measuring span are
outside the permitted measuring
range
S
Press the “+” and “--” buttons to
approach another end position and
acknowledge with the operating
mode button,
or
S
adjust the friction clutch until “
ok
” is
displayed and acknowledge with the
operating mode button
or
S
cancel the initialization by pressing
the operating mode button, switch to
P manual mode and correct the
actuator travel and the position
displacement sensor
ok
only for manual initialization
permitted measuring range of the
end positions has been reached
S
Acknowledge with the operating
mode button, the remaining steps
(“
RUN1
” to “
FINSH
”) run
automatically
RUN 1/
ERROR
x
Error in RUN 1
no movement e.g. due to insufficient
compressed air
S
Make sure there is sufficient
compressed air
S
Open reactor(s)
S
Restart initialization
d___U
x
Bar graph display of the zero point
Zero point is outside the tolerance
range
S
Use friction clutch to set between
“
P 4.0
” and “
P 9.9
” ( >0< )
S
Continue with the “+” or “--” button
SEt
MIDDL
x
x
Friction clutch has been misadjusted;
no “P 50.0” display if the lever is in
horizontal position
S
With linear actuators, press the “+”
and ”--” buttons to move the lever at
right angles to the spindle
S
Press operating mode button briefly
to acknowledge (initialization is
continued)
Summary of Contents for SIPART PS2 6DR50 Series
