Siemens SINAMICS GL150, Operating Instructions Manual

Page: 78 / 168

To extract the load securing device, proceed as follows:
1. Remove the retaining straps.
2. Remove the spacers such as wooden wedges, air cushions, etc.
4.5.3 Lifting the cabinet off the transport pallet
Use a crane to lower the transportation units from the transport pallets and transport them to the
installation site. Observe the guidelines described in the section "Transport with a crane."
4.5.4 Opening doors in preparation for use
NOTICE
Incorrectly opening the doors
If you incorrectly open the doors, then this can damage the locking mechanism.
● When opening the doors, follow the steps described.
● You must replace a damaged locking mechanism before commissioning, which will be
charged for. Contact the service center in this regard. You can find the relevant contact
person under "Service & Support".
When the device is shipped, the doors are closed. To open the doors with the device in a no-
voltage condition, proceed as follows:
1. A screw marked with an adhesive label is located on the door. Under the screw you will find
the opening for manually opening the doors. Loosen this screw.
Figure 4-9 Example: Cover screw for manual door interlocking
2. Insert a screwdriver into this opening.
3. Turn the door handle until you feel resistance.
4. Remove the screwdriver from the opening.
5. Open the doors.
Preparations for use
4.5 Unpacking
SINAMICS GL150 6SL38555UN113KA0Z
78
Operating Instructions Rev.201910281450 EXAMPLE