Siemens SIMATIC RI 45 PIII Series, Manual

Page: 81 / 132

2-53
RI 45 PIII, Manual
C79000-G7076-C817-01
Hard Disk
Timeout [Disabled] Hard disks are not switched off.
[10, 15, 30, 60] Minutes after which the hard disk drive is
switched off, provided it is not being accessed.
If you attempt to access the hard disk after it
has been switched off, there will be an access
delay while the disk is run up again.
PhoenixBIOS Setup-Utility
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Save and Exit
Maximum Power Savings conserves
the greatest amount of system power.
Maximum Performance conserves
power but allows greatest system
performance. To alter these settings,
choose Customized. To turn of power
management, choose Disabled.
Sub-Menu
Power Savings:
Standby Timeout: Off
Suspend Timeout: Off
Hard Disk Timeout: Disabled
Fan Control:
Main Security Power Version
Advanced
Enabled
Disabled
Exit
Enabled
Boot Sequence
Resume On Modem Ring:
[ Off ]
Resume On Time:
[ Off ]
Resume Time: [ 00:00:00 ]
[ Enabled ]
Power Fail Restart:
[ Enabled ]
[ Disabled ]
APM:
Figure 2-25“Power” Submenu
Fan Control Enabled Fan RPM vary according to temperature.
Disabled Fan always runs at a high RPM.
Power Fail
Restart Enabled The device turns itself back on after a power
outtage if the device was on at the time.
Disabled The device does not turn itself back on after a
power outtage.
Resume on
Modem Ring
[
On
]
The “RING” signal allows a modem to be
woken up from Suspend Mode.
Resume On
Time
[
On
]
This function allows the PLC to be
automatically turned back on at a time entered
below.
[ Off ] This function is disabled with Off
Resume Time Time of automatic startup.
Motherboard