Siemens SIMATIC RI 45 PIII Series, Manual

Page: 27 / 132

1-21
RI 45 PIII, Manual
C79000-G7076-C817-01
1.4 Error Diagnostics
Table 1-1 Errors/Faults in PC Operation
Error/Fault Cause Remedy
Power-ON LED does not light up PC is switched off
Power supply is not properly
connected Switch on the PC
Check the power supply
connections, power cable, and
power plug
The message “Invalid
configuration information... Press
the F1 key for continue, F2 to run
SETUP utility” appears on the
screen Incorrect configuration data
Backup battery is low or
defective Press the “F2” key, check the
configuration data in SETUP,
enter any default values, and
check error messages in the first
SETUP menu.
Activate the menu point “Reset
Configuration Data” in the
“Advanced” menu
The “No boot device available”
appears on the screen Diskette in drive A: is not a boot
diskette
Wrong hard disk type entered in
SETUP Use the “Fixed disk function” in
SETUP
“Keyboard stuck; key failure”
message A key has become blocked
during the system keyboard
self-test Check the keyboard
Restart the system
Booting of the PC aborted after
several beeps An error has occured during the
system self-test Check the hardware
Every time a key is pressed, a beep
is heard and no characters appear Keyboard buffer overflow <CTRL> <PAUSE>
Not-ready message when trying to
write to a diskette No diskette has been inserted
Diskette has not been formatted Insert diskette
Format diskette
Write-protect error when trying to
write to a diskette Diskette write-protect activated Cancel write protection
COM 1, COM 2, LPT 1 or
MPI/DP do not respond Ports have been disabled in
SETUP Enable COM 1, COM 2, LPT 1
or MPI in SETUP under
submenu “RI Hardware
Options”
< / > key labeling missing No original keyboard German keyboard: <ALTGR>
<ß> or <ALT> <9> <2>
International keyboard:
<ALT> <9> <2>
< / > key is not displayed Wrong keyboard driver is being
used Load correct keyboard driver
<ALT> <9> <2>
Mouse not working Trackball will not rotate
Missing or wrong mouse driver Clean trackball and housing
Load the right mouse driver
Mouse pointer cannot be moved PS/2 port has been disabled in
SETUP Check SETUP settings
Mouse pointer moving erratically Trackball dirty Clean trackball and housing
System Unit