Mounting and connecting the device
3.2 Mounting the device
SIMATIC IPC477E
36
Operating Instructions, 11/2020, A5E37455003-AF
Procedure
Note
If the mounting seal is damaged or protrudes from the device, the guaranteed degree of
protection is not ensured.
It is prohibited from mounting the device if the mounting seal is damaged.
1. Working from the front, insert the de-
vice into the mounting cut-out. Secure
the device to prevent it from falling out.
2. Insert a mounting clip into the cutout
provided on the device.
3. Tighten the threaded pin to secure the
mounting clip. The maximum torque
when tightening the threaded pins of
the mounting clips is 0.5 Nm.
4. Repeat steps 2 and 3 for all mounting
clips.
5. Check the fit of the mounting seal.
Mounting the device with mounting brackets
If there are strict requirements for the front seal, it might be necessary to fasten the device
with mounting brackets in a cabinet. You can secure each device with 6 mounting brackets.
The mounting brackets are available as accessories.
