Appendix Motherboard
A.1 Jumpers
SIMATIC IPC377E
100
Operating Instructions, 2017/05, A5E40965249-AA
WARNING
Improper operations on the motherboard may result in substantial damage to the
motherboard or endanger the operator.
•
Do not remove or ruin the motherboard serial number labels.
These labels and the serial numbers are required for warranty validation.
•
Wear electrostatic discharge (ESD) wrist strap or gloves when handling or touching the
motherboard.
•
When handling the motherboard, avoid to touch any metal leads or connectors.
•
Always unplug the AC power cord from the power outlet before you installing
or removing the motherboard.
•
Place the motherboard
on an anti‐static pad or in a
electrostatic shielding container
during the operation.
•
Turn off the power supply before you removing the power supply cable from the
motherboard.
•
Before turning on the power supply, check if the input voltage setting follows
the local voltage standard.
•
Before operating the motherboard, make sure that the cables and the
power connectors of all the attached
hardware components are connected. Turning on the power before you connected
them, the motherboard and the system components may get damaged and injure
operator.
•
Make sure you securely attached the hardware components to the motherboard
connectors/ slots/ sockets.
•
The screws are not allowed to connect with motherboard circuit or components. The
motherboard can be get damaged by this action.
•
Do not leave the screws or the metal components on the motherboard or inside of the
chassis.
Setting Jumpers
The board has a number of jumpers that allow you to configure . A jumper is a kind of
electric switch. By setting jumpers, you can configure your card to match the needs of your
application
A jumper consists of two metal pins and a small metal clip (often protected by a plastic
cover). To connect the pins, lid the pin with the clip.
To disconnect a jumper, remove the clip. Some jumpers have three pins, labeled 1, 2 and 3.
In this case you can connect either pins 1 and 2 or 2 and 3. A pair of needle-nosepliers may
be helpful when working with jumpers. if you have any questions about the best hardware
configuration for you application, contact your local distributor or sales representative before
you make any change.
Summary of Contents for SIMATIC IPC377E
Page 4: ...Preface SIMATIC IPC377E 4 Operating Instructions 2017 05 A5E40965249 AA ...
Page 8: ...Table of contents SIMATIC IPC377E 8 Operating Instructions 2017 05 A5E40965249 AA ...
Page 112: ...List of abbreviations SIMATIC IPC377E 112 Operating Instructions 2017 05 A5E40965249 AA ...
Page 124: ...Index SIMATIC IPC377E 124 Operating Instructions 2017 05 A5E40965249 AA ...
