Expanding and assigning parameters to the device
6.4 Memory modules
SIMATIC IPC1047E
62
Operating Instructions, 03/2021, A5E50259546-AA
6.4
Memory modules
6.4.1
Removing memory modules
Requirement
•
The device is open; see section "Open the device. (Page 53)".
•
Observe the "Repair information (Page 79)", in particular for electrostatic sensitive devices
(ESD).
Procedure
1.
Open the two latches at the sides of the memory module evenly. Remove the memory
module from the slot.
2.
Close the device.
Display of a changed memory configuration
A new memory configuration is detected automatically. The allocation of the "base memory
and extended memory" is automatically displayed when you switch on the device.
6.4.2
Installing memory modules
Requirement
•
You have read the manufacturer's information on the Internet: MEMORY CONFIGURATION
X11 UP/DP/MP Motherboards INTEL® XEON
https://www.supermicro.com/support/resources/memory/X11_memory_config_guide.pdf
Note the following:
–
Targeted memory expansion with different memory modules
–
Combination and exact equipping of the memory modules
–
Instructions and conditions for use
•
The device is open; see section "Open the device. (Page 53)".
•
Observe the "Repair information (Page 79)", in particular for electrostatic sensitive devices
(ESD).
