Siemens SIMATIC Field PG P4, Manual

Page: 56 / 144

Configuring And Operating The SIMATIC Field PG P4
3-16
SIMATIC Field PG P4 Manual
A5E00180080-04
3.7 Working with SIMATIC S5 Memory Submodules
Editing SIMATIC S5 Memory Submodules
You can read and program SIMATIC S5 memory submodules (EPROMs or
EEPROMs) via the Memory Card interface. Use the S5 adapter for S5 memory
submodules that is included in the scope of delivery for devices with Step 5
software. The S5 adapter consists of a Memory Card plug with an interface for the
connection of S5 memory modules. Refer to the STEP 5 manual for information on
operating the programming software.
for SIMATIC S5 memory modules
and SIMATIC Memory Cards
Slot for S5 Adapters,
Fig. 3-9 S5 Module Programming Interface
Notice
The S5 adapter and STEP 5 software is not included in all delivered versions.
Proceed as follows when working with S5 memory modules :
1. Switch on your device.
2. In your STEP 5 software, start the function Administration > Edit EPROM.
3. With the type label on the top, insert the SIMATIC S5 Memory Card or the S5
adapter into the Memory Card interface and then the S5 memory module.
4. You can read, program or erase (EEPROMs only) your S5 memory module with
the EPROM functions of the STEP 5 software.
5. Extract the S5 memory module.
6. Close the EPROM functions of your STEP 5 software.
!
Caution
You might damage the module if you insert or extract it while editing is in progress.
You must not remove the S5 memory module as long as the module programming
status display is lit.
Always discharge your body’s static electricity by briefly touching a grounded part
of the device before you insert an S5 Memory Card.