Chapter 4
Modules
RUGGEDCOM MX5000
Installation Guide
26
Installing/Removing Line Modules
RUGGEDCOM MX5000PN LM Blank
Specifications
—
Article Numbers
6GK6050-0ML20-0AA1
Section 4.2
Installing/Removing Line Modules
Upon installing a new line module in the device, all features associated with the module are available in
RUGGEDCOM ROX II. For more information, refer to the
RUGGEDCOM ROX II User Guide
for the RUGGEDCOM
MX5000.
Once a line module is removed, all the features associated with the module are hidden or disabled in RUGGEDCOM
ROX II.
1
2
3
5
6
7
8
4
Figure 16: Line Modules
1.
Ethernet Module Slot (LM1)
2.
Ethernet Module Slot (LM2)
3.
Ethernet Module Slot (LM3)
4.
Control Module (CM)
5.
Switch
Module (SM)
6.
Ethernet Module Slot (LM4)
7.
Ethernet Module Slot (LM5)
8.
Ethernet Module Slot (LM6)
CAUTION!
Contamination hazard – risk of equipment damage. Prevent the ingress of water, dirts and other debris
that may lead to premature equipment failure. Always make sure slots are not left empty and open
ports are protected with plugs or covers.
NOTE
Control and switch modules are not hot swappable. Power to the device must be disconnected before
removing these modules.
Removing a Line Module
To remove a line module, do the following:
