RUGGEDCOM MX5000
Installation Guide
Chapter 3
Device Management
Accessing the CompactFlash Card
19
• The CF card is deemed defective or corrupt
• The device is rendered non-functional due to a serious configuration error, data corruption, or hardware fault
CAUTION!
Configuration hazard – risk of data corruption/loss. The following will void the warranty and
potentially result in configuration data corruption/loss:
• Using a CF card not approved by Siemens for use with this device
• Removing the CF card in any scenario other than those described in this section
Inserting the CF card
To insert the CF card into the device, do the following:
IMPORTANT!
The device should only be powered on when the CF card is present.
1. Make sure the device is powered down.
2. Remove the CF card access panel.
3. Insert the CF card into the slot until it is fully seated.
2
1
Figure 13: Inserting the CF Card
1.
CompactFlash Card
2.
Access Panel
4. Secure the CF card access panel to the chassis.
Removing the CF card
To remove the CF card from the device, do the following:
1. Make sure the device is powered down.
2. Remove the CF card access panel.
