Siemens OP15, Equipment Manual, Page: 138 / 177

B-4
Manual OP5, OP15
( ) J31069-D0840-U001-A2-7618
Action Cause Message
$ 135 Mode change
$ 200 Backup battery voltage has fallen
below minimum value or:
wrong battery type inserted Replace battery
$ 201 Error during clock chip write (hard-
ware error) Return device for repair
$ 202 Error when reading date Re-enter date (return OP for repair)
$ 203 Error when reading time Re-enter time (return OP for repair)
$ 204 Error when reading day Re-enter day (return OP for repair)
$ 205 Printer not ready and internal stor-
age of print jobs is no longer pos-
sible (capacity exceeded) Ready printer or disable message log
$ 206 Printer not ready, print job will be
stored temporarily Ready printer
$ 207 Print job was aborted Check printer, cable and connector
$ 210 Internal error Refer to Action for internal errors
$ 212 Internal error Refer to Action for internal errors
$ 213 Offline mode not possible at present Try mode change again later
$ 214 The job number sent by PLC is too
high Check PLC-user program
$ 217
$ 218 The addresses of two variables
overlap Modify configuration
(variable)
$ 220
$ 221 Printer buffer overflowed, messages
have been lost
$ 222 Event buffer full to remaining
buffer space Delete buffer or configure smaller remaining
buffer space
$ 224 Event buffer full; buffer partially
deleted and forced printout initiated
$ 225 Alarm buffer full to remaining
buffer space Delete buffer or configure smaller remaining
buffer space
$ 227 Alarm buffer full; buffer partially
deleted and forced printout initiated
$ 229 Keyboard connector faulty or loose
(hardware fault) Return device for repair
System Messages