en
Troubleshooting
32
26.1 Malfunctions
Fault
Cause and troubleshooting
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Appliance is not heat-
ing and the colon
flashes in the display.
Demo mode is activated.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and back on again.
2.
Deactivate demo mode within five minutes by changing the basic setting to .
The appliance door
cannot be opened
and lights up in
the display.
The childproof lock locks the appliance door.
▶
Use
to deactivate childproof lock.
The appliance door
cannot be opened
and lights up in the
display.
The cleaning function locks the appliance door.
▶
Allow the appliance to cool down until goes out in the display.
The time flashes in
the display.
There has been a power cut.
▶
Reset the time.
The time does not ap-
pear in the display
when the appliance is
switched off.
The basic setting has been changed.
▶
Change the basic setting for the time display.
lights up in the dis-
play and no settings
can be made on the
appliance.
Childproof lock is activated.
▶
Use the
button to deactivate the childproof lock.
flashes in the dis-
play and the appli-
ance does not start.
The cooking compartment is too hot for the selected operation.
1.
Switch off the machine and allow it to cool.
2.
Restart the operation.
appears in the
display.
The maximum cooking time has been reached. To prevent an unwanted permanent opera-
tion, the appliance automatically stops heating after several hours if the settings are un-
changed.
▶
Switch off the appliance.
Implement new settings, if required.
Tip:
To prevent the appliance from switching off when you do not want it to, e.g. for an
extremely long preparation time, set a cooking time.
"Time-setting options", Page 19
A message with
appears in the dis-
play, e.g. - .
Electronics fault
1.
Press .
‒
If necessary, reset the time on the clock.
a
If the fault was a one-off, the error message disappears.
2.
If the error message appears again, call the after-sales service. State the exact error
message and the E no. for your appliance in full.
26.2 Information on the display panel
Fault
Cause and troubleshooting
No displays light up.
The power supply has been disconnected.
▶
Use other electrical appliances to check whether there has been a power failure.
