Siemens HB36D..5 Series, Instruction Manual

Page: 18 / 36

18
Automatic switch-off
If you do not change the settings on your appliance for several
hours, the automatic switch-off function will be activated.
"Automatic switch-off" appears in the display.
Press any button to deactivate the automatic switch-off. You
can now make new settings.
Care and cleaning
In this section, you will find information on
■
care and cleaning of your appliance
■
the cleaning aid
■
descaling
ã=
Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of surface damage: Do not use
■
harsh or abrasive cleaning agents
■
oven cleaners
■
corrosive or aggressive cleaners, or those containing
chlorine
■
cleaning agents with a high alcohol content
If such an agent comes into contact with the front of the
appliance, wash it off immediately with water.
Caution!
Risk of surface damage: If descaler or the oven and grill
cleaning gel comes into contact with the front of the appliance
or other sensitive surfaces, wash it off immediately with water.
Remove food residues from the cooking compartment as soon
as the appliance has cooled. Burnt-on remains will be much
harder to remove later.
For heavy soiling use the cleaning aid (see section: Cleaning
aid).
Salts are very corrosive and can cause rust. Remove remains
of acidic sauces (ketchup, mustard) or salted food from the
cooking compartment immediately after cooling.
Do not use hard scouring pads or cleaning sponges.
Adjust individually Sets programme cooking results to be generally higher or
lower
7 levels -
ÙÙÙÙØÙ
+
Display brand logo Switches the brand name logo display on or off when the
appliance is switched on
on / off
Water hardness Sets the water hardness range for the descaling indicator softened / 1-soft / 2-medium / 3-
hard / 4-very hard
Steam cooking heat signal: Audible signal at the end of the heating up phase during
steaming
off / on
Restore factory settings Restores the appliance to the factory settings:
■
All changes to the basic settings are cleared
■
Memory is cleared
■
Automatic calibration is carried out again
do not restore /
restore
Basic setting Function Possible settings