Siemens EX8xxxKYE1E Series, Instruction Manual, Page: 22 / 40

en
Cooking assist functions
22
Connecting the wireless temperature sensor to the
control panel
You will need to connect the wireless temperature
sensor to the control panel before using the cooking
functions for the first time.
1.
Open the docking menu.
2.
Open the basic settings and select "Cooking sensor"
from the menu.
3.
Select the "Add new cooking sensor" option.
Press the
»
symbol on the wireless temperature
sensor within 30 seconds.
After a few seconds, the status of the connection
between the temperature sensor and the control
panel will appear on the display.
The cooking functions are made available once the
temperature sensor has been connected to the control
panel correctly.
Notes
■
If there is a fault with the temperature sensor, the
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
– You did not press the symbol on the temperature
sensor within 30 seconds of selecting a hotplate.
– The battery in the temperature sensor has run
out.
Reset the temperature sensor and follow the
connection procedure once again.
■
If the temperature sensor and the control panel are
not connected correctly due to a transmission error,
follow the connection procedure once again.
If the display continues to indicate an incorrect
connection, contact our technical after-sales service.
Resetting the wireless temperature sensor
1.
Touch and hold the
»
symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
2.
Repeat the connection procedure from point 2.
Setting procedure
1.
Attach the temperature sensor to the saucepan; see
the section on
~
"Preparing and maintaining the
wireless temperature sensor"
2.
Place a saucepan filled with sufficient liquid on the
required hotplate and always put the lid on.
3.
Select the cooking zone on which you have placed
the cookware with the temperature sensor. In the
cooking zone's cooking mode menu, select the
cooking functions cooking mode.
4.
Touch the
»
symbol for the wireless temperature
sensor.
5.
Select the right temperature setting from the table.
The function has now been activated.
The temperature symbol
»
will flash until the water
or oil has reached the right temperature for adding
the food.When the temperature has been reached,
an audible signal will sound. The temperature
symbol
»
will stop flashing and will remain lit
continuously.
6.
Once the signal has sounded, take the lid off and
add the food. Keep the lid on during cooking.
Note: .
Do not cover the pan when using the "Frying
with a large amount of oil in the saucepan" function.
Switching off cooking functions
Select a cooking zone and set the power setting to 0 on
the control panel. The cooking zone will switch itself off
and the residual heat indicator will appear.