Siemens ET6 LNV1 Series, User Manual, Page: 19 / 24

Troubleshooting
en
19
17.1 Information on display panel
Fault Cause and troubleshooting
None There has been a power cut.
1.
Check the household fuse for the appliance.
2.
Check whether there has been a power failure by trying other electrical appli-
ances.
All displays flash Controls are wet or objects are lying on top.
▶
Dry the controls or remove the object.
Several hotplates have been used over a prolonged period at high power set-
tings. The hotplate has been switched off to protect the electronics.
1.
Wait a while.
2. Touch any control.
a
When the message no longer appears, the electronics have cooled down
sufficiently. You can continue cooking.
Despite being switched off by , the electronics have become hot again. All
hotplates have therefore been switched off.
1.
Wait a while.
2.
Touch any control.
a
When the message no longer appears, the electronics have cooled down
sufficiently. You can continue cooking.
and the heat setting flash al-
ternately. A signal sounds.
Hot pan near the control elements. There is a risk of the electronics overheating.
▶
Remove the pan.
a
The display goes out shortly afterwards.
and audible signal Hot pan near the control elements. The hotplate has been switched off to pro-
tect the electronics.
1. Remove the pan.
2.
Touch any control.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue cooking.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
and hotplates do not heat up Demo mode is activated.
1.
Disconnect the appliance from the power supply for 30 seconds by briefly
switching off the circuit breaker in the fuse box.
2.
Touch any control within the next 3 minutes.
A message with "E" appears on
the display, e.g. E0111. The electronics have detected a fault.
1.
Switch the appliance off and on again.
a
If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the
exact error message when calling.
→
"Customer Service", Page 20
17.2 Home Connect problem
Fault Cause and troubleshooting
HomeConnect is not working cor-
rectly. Different causes are possible.
▶
Go to www.home-connect.com.