Siemens CIM4 10 PROFINET FW V2 Series, Configuration, Page: 63 / 81

7 Installation and Commissioning
7.2 Network connections
HCS4x00Library
Entry ID: 109478117, V2.2.1, 09/2018
63

S
ie
m
e
n
s
A
G
2018
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
Note Always follow the installation guidelines in order to connect all the components.

SIMATIC S7-1500 ( \8\ )

SIPLUS HCS 4200: Chapter "Safety information and guidelines" ( \4\ )

SIPLUS HCS 4300: Chapter "Safety information and guidelines" ( \5\ )
Table 7-1
No. Action Remark
1. Mount the SIPLUS HCS4200 and connect it
(
\10\ ).
When using the SIPLUS HCS4300 see \11\
2. Wire and connect all other required
components as described. See S7-1500 Manual ( \8\ )
3. Plug the empty memory card into the S7-1500
CPU (
Table 2-2 ).
See chapter “Plug/Pull SIMATIC Memory Card
at the CPU” (S7-1500 manual
\8\ )
4. Finally, connect the SIMATIC PM 1507 power
supply module to the AC power system
(230 V) and supply the HCS with power.
7.2 Network connections
The LAN network card of the programming device requires a static IP address to
configure the controller.
The configuration of the LAN connection is described in the following.
Table 7-2
No. Action Remark
1.
Click “Start > Control Panel > Network and
Sharing Center > Change adapter settings”
to open the network connections.

Select your network connection.

Right-click to open the properties.