SD66
6
3.
Install a new or existing (as required) diaphragm ring.
NOTE
When viewed from above, diaphragm ring in amplifying position has recessed, machined
area with vent path to exhaust vent hole. Note that exhaust vent hole is positioned over
supply connection in amplifying and reducing relays.
4.
Install input diaphragm assembly and top forging.
5.
Refer to Calibration section and calibrate relay.
6.
Document change on drawings, records, etc. Label the relay with the new model number.
Table 2 Diaphragm Rings and Output Diaphragm Assemblies
Product Support
This section provides the Internet site address, e-mail address, telephone numbers,
and related information for customers to access Siemens product support.
When contacting Siemens for support:
•
Please have complete product information at hand:
•
For hardware, this information is provided on the product nameplate
(part number or model number, serial number, and/or version).
•
For most software, this information is given in the Help > About screen.
•
If there is a problem with product operation:
•
Is the problem intermittent or repeatable? What symptoms have been observed?
•
What steps, configuration changes, loop modifications, etc. were performed before the problem
occurred?
•
What status messages, error messages, or LED indications are displayed?
•
What troubleshooting steps have been performed?
•
Is the installation environment (e.g. temperature, humidity) within the product’s specified operating
parameters? For software, does the PC meet or exceed the minimum requirements (e.g. processor,
memory, operating system)?
•
A copy of the product Service Instruction, User’s Manual or other technical literature should be at hand. The
Siemens public Internet site (see the table) has current revisions of technical literature, in Portable Document
Format, for downloading.
StockCheck.com
Downloaded from StockCheck.com
