Setup
menu
Parallel
The parallel interface PAR can be set here.
Possible settings:
LPT1 (378h)
The parallel interface PAR is set to address 378h and IRQ7.
LPT3 (3BCh)
The parallel interface PAR is set to address 3BCh and IRQ7. If you use
this setting, the entry in the field
Par Mode
must be set to
PRINTER
.
DISABLED
The parallel interface PAR is off.
Default setting:
LPT1 (378h)
Par Mode
You can define here the transmission mode of the parallel interface.
Possible settings:
PRINTER
The parallel interface PAR can only send.
BIDIRECTION
Additional software enables the parallel interface PAR to send and
receive.
EPP
Enhanced Parallel Port. The enhanced parallel transmission according to
EPP is supported.
ECP
Extended Capabilities Port. The fast parallel transmission according to
ECP is supported.
EPP AND ECP
The transmission according to EPP and ECP is supported.
Default setting:
PRINTER
A26361-D802-Z121-3-7619
13
Setup menu
Diskette Write
This field allows you to define whether floppy disks can be written and
deleted. The jumper in X180 must be set to 3-12, to write and delete floppy
disks.
Possible entries:
ENABLED
Floppy disks can be read, written or deleted.
DISABLED
Floppy disks can be read only.
Default entry:
ENABLED
Diskette CTRLR
This field allows you to disable the diskette controller on the system board.
Possible entries:
ENABLED
The diskette controller on the system board is on.
DISABLED
The diskette controller on the system board is off.
Default entry:
ENABLED
HD Ctrlr Mode
With this input field, you can set the transmission speed of the IDE hard disk.
If the integral IDE hard disk drive does not support this function, select the
STANDARD
entry.
Possible entries:
STANDARD
Normal transmission speed.
4K BLOCK XFER
High transmission speed.
This setting is supported by most hard disks with a disk buffer of four
KBytes or more.
Default entry:
STANDARD
14
A26361-D802-Z121-3-7619
