7
5630
6
2019
-
SX35 & SX50
MC_0072
Positioning the stern truster
EN
For best performance, the thruster must be installed as deep on the stern as possible and the thrusters water fl ow must not obstruct any objects.
The thruster should be installed as deep under the waterline as possible for two reasons:
1. So it does not suck air from the surface which will reduce performance and increase noise levels.
2. To receive maximum effi ciency and thrust.
The thruster must be installed to ensure the propulsion water fl ow must not be obstructed by other objects. Objects that obstruct the water fl ow will
greatly reduce the thrust output.
Position
The thruster can be installed in multiple locations on the boat transom. Installing the thruster slightly off centre will not aff ect the overall eff ectiveness of
the thruster. Installing the thruster off centre may be required to avoid any obstructions externally or internally on the vessel.
Ensure that the external stern thruster assembly does not disturb the water fl ow under the hull. At higher speeds, if the thruster is installed to
low can cause damage to the thruster, additional drag and unwanted water splashing.
Alignment
The thruster can be installed at a slight angle if required for the water fl ow to avoid obstructions. These obstructions can include propellers systems, trim
tabs or the hull. The average force the thruster propels water is 5-7 meters per sec, therefore angled installations must be as deep as possible under the
water to minimise spray breaking beyond the water surface.
(NB: install the truster at an angle only if no other suitable location can be found.)
Max hull thickness 50mm include spacer
MG_0109
Thruster tunnel is clear
from obstruction.
Ensure the attachment bolts and
wiring are not obstructing objects
internally in the boat such as
steering legs or motors
Steering Arm
Installing the thruster at an angle
close to the water line will blast
water beyond the water surface.
Engine
The thruster can be installed in multiple
locations based on object obstructions
on the stern.
Engine
Water line
Water line
Water line
Engine
Engine
Thruster assembly does not disturb
the water flow under the hull.
Water flow
MC_0082
Control Box Technical Specifi cations
EN
SX35
SX50
Operation volts:
12v.
12v
Max Current:
250A
380A
Duty Cycle:
S2.
S2
Max ambient temp:
50ºc
50ºc
Min ambient temp:
-25ºc
-25ºc
Power supply cable:
35 - 70mm²/ AWG 2 - 00
35 - 70mm²/ AWG 2 - 00
Mount direction :
Any
Any
MG_0132
121 mm
4’76”
187 mm
7’36”
170 mm
6’69”
136 mm 5’35”
110 mm 4’33”
