Side-Power SX-35/140, Installation Manual

Page: 19 / 24

19
5630 6 2019
-
SX35 & SX50
MG_0041
++
BLUE HOSE
*approx (900mm/ 35”)
THRUSTER
CONTROLLER
(MUST BE IGNITION PROTECTED IF
LOCATED IN IP REQUESTED AREA)
THRUSTER
BATTERY
12V B-
B+
+ Signal cable
B+
Thru
ste
r +
B+
Thru
ste
r +
AUTOMATIC
MAIN SWITCH
(AMS)
To control panel(s)/remote.
CONTROLLER CONNECTIONS:
<<B+>>: Power supply pos from thruster battery/ Main switch/ Main fuse
<<B->>: Power supply neg from thruster battery
2 Motor cables from thruster
4 wires from thruster overtemp switch
2 Control cables from control panel(s)/ remote
Visual Wiring Diagram
EN
Control Panel Installation
EN
Find a comfortable location for the control panel where it does not obstruct or is obstructed by other controls. Install the control panel where it is easy
to use. (NB: As a guide the side thruster if often operated together with the gear/throttle control. For the optimal user-friendly solution install
the control panel where access to both controls are accessible with one hand for each control.)
1. Use the enclosed cut-out template to mark the area to remove on your control dash.
2. Cut out the area per template for the control panel. ( NB: If the front surface around your cut out is jagged or chipped, use a sealant
to assist the gasket.)
3. Place the gasket to the back face of the panel
4. Plug cables into the connectors at the rear of the control panel. (NB: Twist the locking ring on the connector clockwise to secure connector.)
5. Insert the control panel in place and fasten screws.
6. insert the control panels covering caps.
MC_0042
!
Please refer to the graphic for special considerations relating to your model
!
MG_0026
50
,5mm
38
,4mm
Ø52
Ø52
61,1mm
11
1,1mm
This way Up!
Cut-Out Template
double joystick panel - 8940
For control panels
8955/8965/8990
Ø 2,5 mm / 0,10"
53,0 mm / 2,09"
53
,0
mm
/ 2
,0
9"
Cut out area:
Ø 51,8 mm / 2"
Cut out area:
Ø 51,8 mm / 2"
61,0 mm / 2,4"
61
,0
m
m
/ 2
,4
"
For control panels 8950 / 8960
Ø 3,0 mm / 0,12"
For control panels
8955/8965/8990
Ø 2,5 mm / 0,10"
53,0 mm / 2,09"
53
,0
mm
/ 2
,0
9"
Cut out area:
Ø 51,8 mm / 2"
Cut out area:
Ø 51,8 mm / 2"
61,0 mm / 2,4"
61
,0
m
m
/ 2
,4
"
For control panels 8950 / 8960
Ø 3,0 mm / 0,12"
(4) COVERING CAPS
CONTROL PANEL TEMPLATES
(4) COVERING CAPS
COVERING CAP
GASKET
CABLES
CABLES
CABLES
GASKET
GASKET
(4) SCREWS
(4) SCREWS
(4) SCREWS