6
5693
2
2019
-
SE60/185 S2
Propeller Installation
EN
1. Centre the drive pin on the propeller shaft and rotate the shaft, so the pin is in a horizontal state.
2. Insert the propeller onto the shaft and rotate the propeller until the drive pin aligns into the slot/ groove in the propeller.
(NB: Installation requires almost no gap (approximately 1mm) between the propeller and the gear leg.)
3. Insert the washer on the propeller shaft and fasten the propeller lock-nut.
(NB: Ensure the propeller turns freely.)
4. Insert the anode to the end of the propeller and fasten the anode holding screw. Apply a thread glue (Loctite or similar) to ensure that the anode
holding screw does not un-screw itself from during the rotation of the propeller.
MC_0018
!
Please refer to the graphic for special considerations relating to your model
!
MG_0028
Anode holding screw
Anode
lock nut
washer
propeller
drive pin
