![background image](http://html.mh-extra.com/html/sick/tr10-lock/tr10-lock_operating-instructions-manual_1264350018.webp)
Figure 8: The guard locking pin must first pass through the mounting bracket
°
The alignment triangles on the actuator and safety switch must be on the
same side and point to one another.
Figure 9: Correct alignment between safety switch and actuator
2.
Depending on the alignment and environmental influences, dirt may accumulate
in the actuator. In this case, use a screwdriver to pry the sealing plug out of the
actuator. This will prevent dirt from accumulating in the actuator.
Figure 10: Remove sealing plug if necessary
3.
Fit mounting bracket onto the movable protective device with at least 2 M5
screws. Make sure that at least 1 screw uses a drill hole near the actuator (
).
M5
M5
Figure 11: Fasten mounting bracket in place with at least 2 M5 screws
5
MOUNTING
18
O P E R A T I N G I N S T R U C T I O N S | TR10 Lock
8019972/2016-07-19 | SICK
Subject to change without notice