6.4
Multiprogramming different device types using the PGT memory
NOTE
To prepare the parameter sets, the PGT-12-Pro must always be connected to a suitable
device.
NOTE
Not available for sensors with interface SAE J1939.
Preparation
WARNING
Only use an adapter cable that is suitable for the device (see "Facilities for connecting").
The programming tool must only be used with the designated adapter cables. Other
adapter cables are not permitted. Their use could result in damage to the programming
tool and/or the connected device.
The PGT-12 Pro must be switched off before the device is disconnected from the
electrical connection.
•
Connect a device of the type to be programmed to the PGT-12-Pro (see "Connect‐
ing to the device").
•
Apply all the desired settings for the parameter values.
•
Save the previously set parameter values in the PGT-12-Pro using the
Save Config‐
uration to PGT-12-Pro
function.
Programming devices
•
Connect an additional device to be programmed to the PGT-12-Pro (see “Connect‐
ing to the device”).
•
Load the parameters for the device type to be programmed to the memory using
the Read Configurations from the PGT-12-Pro function.
•
Program the connected device using the
Program...Configuration File from Mem‐
ory
function.
The saved parameter set is transferred to the device.
•
Disconnect the device from the adapter cable.
The device is fully programmed and ready to use.
Programming additional devices
Repeat the steps under “Programming devices” for all other devices.
OPERATING INSTRUCTIONS
28
O P E R A T I N G I N S T R U C T I O N S | PGT-12-Pro
8019724/1EJJ/2022-01-05 | SICK
Subject to change without notice