![background image](http://html1.mh-extra.com/html/sick/io-link-master-iolg2ei-03208r01-ethernet-ip/io-link-master-iolg2ei-03208r01-ethernet-ip_operating-instructions-manual_1264554033.webp)
© SICK AG • Presence Detection • Subject to change without notice • 8018483
33
Operating instructions IO-Link Master IOLG2EI-03208R01 – EtherNet/IP™
Operation on the IO-Link Master
7.1.2
Configuring display LEDs
The display LEDs are configured via the process data outputs.
→
See Page 28, Table 22 “Standard output data”.
7.2
Modes and displays
7.2.1
Operating mode
The IO-Link Master is in operation when in operating mode. The display
shows the fourth octet of the IP address.
7.2.2
Edit mode and fast-scroll mode
The display flashes in edit mode.
Calling up edit mode
Edit mode is activated by pressing the “Set” pushbutton for at least 3 sec
-
onds.
If no pushbuttons are pressed for 10 seconds, the display returns to oper
-
ating mode. Any changes that have not been saved are lost.
Differences between the new configuration and the current active config
-
uration are indicated by the “not equal” sign (≠). In this case, the display
returns to operating mode after 5 seconds.
Fast-scroll mode
To use fast-scroll mode, you must be in edit mode. Fast-scroll mode is acti
-
vated by pressing and holding the “Arrow” pushbutton. The display flickers
in fast-scroll mode.
7.2.3
Ping mode
You can use the ping command to check whether the IO-Link Master is
reachable. The ping command is entered via the PC.
Display
Description
ping
The IO-Link Master has received a ping command. “ping”
appears on the display for several seconds. It then returns
to the previous display. You can exit ping mode immediate
-
ly by pressing the “S” pushbutton.
Ping
The IO-Link Master has received several ping commands.
You can only exit the display by pressing the “S” pushbut
-
ton. It returns to the previous display.
Table 27: Display in ping mode